2-Oleoylglycerol is a naturally occurring lipid in the diet. 2-Oleoylglycerol is a GPR119 agonist that activates hGPR119 in transiently transfected COS-7 cells with EC50 of 2.5 μM. 2-Oleoylglycerol stimulates glucagon-like peptide 1 (GLP-1) secretion in vivo.

Physicochemical Properties

Molecular Formula	C21H40O4
Molecular Weight	356.55
Exact Mass	356.293
CAS #	3443-84-3
PubChem CID	5319879
Appearance	Colorless to light yellow liquid
Density	0.969 g/cm3
Boiling Point	485.4ºC at 760mmHg
Flash Point	113ºC
Index of Refraction	1.478
LogP	4.92
Hydrogen Bond Donor Count	2
Hydrogen Bond Acceptor Count	4
Rotatable Bond Count	19
Heavy Atom Count	25
Complexity	311
Defined Atom Stereocenter Count	0
SMILES	CCCCCCCC/C=C\CCCCCCCC(=O)OC(CO)CO
InChi Key	UPWGQKDVAURUGE-KTKRTIGZSA-N
InChi Code	InChI=1S/C21H40O4/c1-2-3-4-5-6-7-8-9-10-11-12-13-14-15-16-17-21(24)25-20(18-22)19-23/h9-10,20,22-23H,2-8,11-19H2,1H3/b10-9-
Chemical Name	1,3-dihydroxypropan-2-yl (Z)-octadec-9-enoate
Synonyms	2-Monoolein; 2-Oleoylglycerol; 3443-84-3; 2-Monooleoylglycerol; 2-oleoyl-glycerol; 2-Glyceryl monooleate; Glyceryl 2-oleate; Glycerol 2-monooleate;
HS Tariff Code	2934.99.9001
Storage	Powder-20°C 3 years 4°C 2 years In solvent -80°C 6 months -20°C 1 month
Shipping Condition	Room temperature (This product is stable at ambient temperature for a few days during ordinary shipping and time spent in Customs)

Biological Activity

Targets	IC50: 2.5 μM (hGPR119) (in COS-7 cells)[1]
ln Vitro	2-oleoyl glycerol (2OG) and other 2-monoacylglycerols increased intracellular concentrations of cAMP in GPR119-expressing COS-7 cells (2OG EC(50) = 2.5 μm). Administration of 2OG to humans significantly increased plasma GLP-1 (0-25 min) when compared to the two controls, oleic acid and vehicle. Plasma levels of glucose-dependent insulinotropic polypeptide also increased. Conclusion: 2OG and other 2-monoacylglycerols formed during fat digestion can activate GPR119 and cause incretin release from the human intestine. This mechanism is likely to contribute to the known stimulatory effect of dietary fat on incretin secretion, and it indicates that GPR119 is a fat sensor[1].
ln Vivo	The effect of a jejunal bolus of 2 g 2OG on plasma levels of GLP-1 was evaluated in eight healthy human volunteers. The effect of 2OG was compared to an equimolar amount of oleic acid, a degradation product from 2OG, and the vehicle, glycerol. Digestion of 5 ml olive oil with pancreatic lipase will result in formation of approximately 2 g 2OG and 3.2 g oleic acid[1].
Enzyme Assay	The pharmacology of monoacylglycerol lipase (MAGL) is not well understood. In consequence, the abilities of a series of analogues of 2-arachidonoylglycerol (2-AG) to inhibit cytosolic 2-oleoylglycerol and membrane-bound anandamide hydolysis by MAGL and fatty acid amide hydrolase (FAAH), respectively, have been investigated. 2-AG and its 1-regioisomer (1-AG) interacted with MAGL with similar affinities (IC(50) values 13 and 17 mum, respectively). Shorter homologues of 2-AG (2-linoleoylglycerol and 2-oleoylglycerol) had affinities for MAGL similar to 2-AG. This pattern was also seen when the arachidonoyl side chain of arachidonoyl trifluoromethylketone was replaced by an oleoyl side chain. Arachidonoyl serinol (IC(50) value 73 microM) was a weaker inhibitor of MAGL than 2-AG. The IC(50) values of noladin ether towards MAGL and FAAH were 36 and 3 microM, respectively. Arachidonoyl glycine interacted with FAAH (IC(50) value 4.9 microM) but only weakly interacted with MAGL (IC(50) value >100 microM). alpha-Methyl-1-AG had similar potencies towards MAGL and FAAH (IC(50) values of 11 and 33 microM, respectively). O-2203 (1-(20-cyano-16,16-dimethyl-eicosa-5,8,11,14-tetraenoyl) glycerol) and O-2204 (2-(20-hydroxy-16,16-dimethyl-eicosa-5,8,11,14-tetraenoyl) glycerol) were slightly less potent, but again affected both enzymes equally. alpha-Methyl-1-AG, O-2203 and O-2204 interacted only weakly with cannabinoid CB(1) receptors expressed in CHO cells (K(i) values 1.8, 3.7 and 3.2 microM, respectively, compared with 0.24 microM for 1-AG) and showed no evidence of central cannabinoid receptor activation in vivo at doses up to 30 mg kg(-1) i.v. It is concluded that compounds like alpha-Methyl-1-AG, O-2203 and O-2204 may be useful as leads for the discovery of selective MAGL inhibitors that lack direct effects upon cannabinoid receptors[2].
Cell Assay	Agonist activity for various lipids was tested on transiently expressed human GPR119 in COS-7 cells.
References	[1]. 2-Oleoyl glycerol is a GPR119 agonist and signals GLP-1 release in humans. J Clin Endocrinol Metab. 2011 Sep;96(9):E1409-17. [2]. Inhibition of monoacylglycerol lipase and fatty acid amide hydrolase by analogues of 2-arachidonoylglycerol. Br J Pharmacol. 2004 Nov;143(6):774-84.
Additional Infomation	2-oleoylglycerol is a 2-monoglyceride where the acyl group is (9Z)-octadecenoyl. It is a monooleoylglycerol and a 2-acylglycerol 18:1. It is functionally related to an oleic acid. 2-Monoolein has been reported in Medicago sativa, Sciadopitys verticillata, and Trypanosoma brucei with data available.

Solubility Data

Solubility (In Vitro)

May dissolve in DMSO (in most cases), if not, try other solvents such as H2O, Ethanol, or DMF with a minute amount of products to avoid loss of samples

Solubility (In Vivo)

Note: Listed below are some common formulations that may be used to formulate products with low water solubility (e.g. < 1 mg/mL), you may test these formulations using a minute amount of products to avoid loss of samples. Injection Formulations (e.g. IP/IV/IM/SC) Injection Formulation 1: DMSO : Tween 80： Saline = 10 : 5 : 85 (i.e. 100 μL DMSO stock solution → 50 μL Tween 80 → 850 μL Saline) *Preparation of saline: Dissolve 0.9 g of sodium chloride in 100 mL ddH ₂ O to obtain a clear solution. Injection Formulation 2: DMSO : PEG300 ：Tween 80 : Saline = 10 : 40 : 5 : 45 (i.e. 100 μL DMSO → 400 μLPEG300 → 50 μL Tween 80 → 450 μL Saline) Injection Formulation 3: DMSO : Corn oil = 10 : 90 (i.e. 100 μL DMSO → 900 μL Corn oil) Example: Take the Injection Formulation 3 (DMSO : Corn oil = 10 : 90) as an example, if 1 mL of 2.5 mg/mL working solution is to be prepared, you can take 100 μL 25 mg/mL DMSO stock solution and add to 900 μL corn oil, mix well to obtain a clear or suspension solution (2.5 mg/mL, ready for use in animals). Injection Formulation 4: DMSO : 20% SBE-β-CD in saline = 10 : 90 [i.e. 100 μL DMSO → 900 μL (20% SBE-β-CD in saline)] *Preparation of 20% SBE-β-CD in Saline (4°C，1 week): Dissolve 2 g SBE-β-CD in 10 mL saline to obtain a clear solution. Injection Formulation 5: 2-Hydroxypropyl-β-cyclodextrin : Saline = 50 : 50 (i.e. 500 μL 2-Hydroxypropyl-β-cyclodextrin → 500 μL Saline) Injection Formulation 6: DMSO : PEG300 : castor oil : Saline = 5 : 10 : 20 : 65 (i.e. 50 μL DMSO → 100 μLPEG300 → 200 μL castor oil → 650 μL Saline) Injection Formulation 7: Ethanol : Cremophor : Saline = 10： 10 : 80 (i.e. 100 μL Ethanol → 100 μL Cremophor → 800 μL Saline) Injection Formulation 8: Dissolve in Cremophor/Ethanol (50 : 50), then diluted by Saline Injection Formulation 9: EtOH : Corn oil = 10 : 90 (i.e. 100 μL EtOH → 900 μL Corn oil) Injection Formulation 10: EtOH : PEG300：Tween 80 : Saline = 10 : 40 : 5 : 45 (i.e. 100 μL EtOH → 400 μLPEG300 → 50 μL Tween 80 → 450 μL Saline) Oral Formulations Oral Formulation 1: Suspend in 0.5% CMC Na (carboxymethylcellulose sodium) Oral Formulation 2: Suspend in 0.5% Carboxymethyl cellulose Example: Take the Oral Formulation 1 (Suspend in 0.5% CMC Na) as an example, if 100 mL of 2.5 mg/mL working solution is to be prepared, you can first prepare 0.5% CMC Na solution by measuring 0.5 g CMC Na and dissolve it in 100 mL ddH2O to obtain a clear solution; then add 250 mg of the product to 100 mL 0.5% CMC Na solution, to make the suspension solution (2.5 mg/mL, ready for use in animals). Oral Formulation 3: Dissolved in PEG400 Oral Formulation 4: Suspend in 0.2% Carboxymethyl cellulose Oral Formulation 5: Dissolve in 0.25% Tween 80 and 0.5% Carboxymethyl cellulose Oral Formulation 6: Mixing with food powders Note: Please be aware that the above formulations are for reference only. InvivoChem strongly recommends customers to read literature methods/protocols carefully before determining which formulation you should use for in vivo studies, as different compounds have different solubility properties and have to be formulated differently.  (Please use freshly prepared in vivo formulations for optimal results.)

Preparing Stock Solutions		1 mg	5 mg	10 mg
	1 mM	2.8047 mL	14.0233 mL	28.0466 mL
	5 mM	0.5609 mL	2.8047 mL	5.6093 mL
	10 mM	0.2805 mL	1.4023 mL	2.8047 mL

*Note: Please select an appropriate solvent for the preparation of stock solution based on your experiment needs. For most products, DMSO can be used for preparing stock solutions (e.g. 5 mM, 10 mM, or 20 mM concentration); some products with high aqueous solubility may be dissolved in water directly. Solubility information is available at the above Solubility Data section. Once the stock solution is prepared, aliquot it to routine usage volumes and store at -20°C or -80°C. Avoid repeated freeze and thaw cycles.